Besa Lighting Sola (Flush Mount) - Manual

6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
CEILING FIXTURE INSTALLATION GUIDE
Models using B0005C Series Ceiling Pan (Med. Base 120V)
B0005C, B0006C, Rev.4 12-10
Use With
these Models:
• Geo 9
(8884xx)
• Bobbi 10
(9111xx)
• Sola 10
(9432xx)
• Katie 10
(945107)
Caution: Turn off power to electrical box before installing
CAUTION-RISK OF FIRE: Min 90C SUPPLY CONDUCTORS. This fixture requires that the branch supply wires
be rated: MIN 90C. Most dwellings built before 1985 have supply wire rated 60C.
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
1. Carefully unpack parts. Fasten Mounting Strap (A) to Outlet box
with Machine Screws (B).
2. Attach supply ground conductor to Mounting Strap with the green
ground screw( C).
3. Thread the Threaded Nipple (D) into the Mounting Strap as shown.
4. Connect the fixture conductors to the supply
conductors with wire nut connectors (E) as shown:
White fixture wire to white supply wire and black
fixture wire to black supply wire. Carefully push
wires and wire nuts back into outlet box.
5. Place the fixture Canopy (F) over the outlet box
so that the Threaded Nipple protrudes through
the center mounting hole in canopy.
6. Secure the Canopy to the ceiling with the
Star Washer (G) and Cap Nut (H), as shown.
Tighten the cap nut firmly by using pliers.
7. Insert the three Set Screws (I) into the three
threaded bushings on the sides of the Canopy.
Turn the Set screws 2-3 turns, not allowing any
of the screw head to extend into the inside
of the canopy.
8. Insert bulb(s) of indicated type and wattage
marked on fixture. Do not exceed wattage,
as that could cause fixture to overheat.
9. Insert the Glass Diffuser (J) into the Canopy
until it seats flush with the rim of the canopy.
Secure the glass in place by tightening the
three Set Screws by hand with a screwdriver.
DO NOT OVERTIGHTEN as damage to
glass may result.
10. Restore power.
A
B
C
D
E
F
G
H
I
J