Datalogic Scanning FALCON 4400 SERIES - Manual (Page 97)

Product Reference Guide E-1
Appendix E
Programming Parameters
Overview
This section contains information about programmable settings for the Falcon
4400 Windows Mobile Falcon. Use the Falcon Management Utility (FMU),
the Scanner Control Panel applet, the Imaging or OCR Control Panel applets,
or the bar codes provided in
Appendix F to program the Falcon.
Table E-2 starting on page E-3 provides the following information:
• Code Parameter is the “human” name for the programming option.
• I.D. # is the “decoder” name for the programming option. For example,
to set a Code 39 minimum label length, use I.D. 0120. Program-
ming I.D. numbers given in this appendix can be used with all pro-
gramming methods.
• Type tells what kind of setting to use for each code parameter.
• On/Off is a toggle. 1 turns the parameter on, and 0 turns it off.
• Acceptable Input gives the settings or range of settings for each code
parameter.
• Defaults indicates how the parameter is set when the predefined
default FF39, FF3A, or FF3B is selected.
• Minimum (
FF39
) turns every on/off parameter off and sets all min-
imum and Maximum Label Lengths to the lowest values.
• Maximum (
FF3A
) turns every on/off parameter on, sets all Mini-
mum Label Lengths to the lowest values, and sets all Maximum
Label Lengths to the highest values. Use this default for trouble-
shooting; it provides the best settings for reading an unknown bar
code symbology and can identify the symbology of scanned bar
codes.
• Factory ( FF3B ) is the factory setting installed on the Falcon. This
default set will work for most applications. To reset the Falcon to
the original defaults, scan the
Factory bar code on page F-3 .