Datalogic Scanning FALCON 4400 SERIES - Manual (Page 127)

Bar Code Parameters
Product Reference Guide E-31
Table E-4. Imaging Controls
QR Code
Maximum
This feature specifies the maxi-
mum allowable length of a label.
The length includes check and
data characters, if applicable.
Maximum Label Length should be
greater than or equal to Minimum
Label Length.
0
B
2
9
1 - 3500 1 3500 3500
9
QR Code
User ID
Specifies the symbology identifier
(if any) that is sent when parame-
ter Send Code ID (Index 0025) is
set to 3.
ASCII code zero (null) is
used to indicate that an identifier is
not to be sent for the symbology.
0
B
2
B
Any sin-
gle
ASCII
charac-
ter (00 =
Off)
‘c’ ‘c’ ‘c’
9
Code Parameter/ Description
I.
D.
#
Accep-
table
Input
Defaults
Min Max Factory
Imaging Controls
Enter 1 for On and 0 for Off.
Imager Illu-
minate
Enable Instructs the PDT to illuminate the scanning
area (independent of any targeting beam)
when using an imager.
0
0
0
8
On or
Off
On On On
Imager Aim
Mode
Toggles between two different operating
modes for the targeting beam:
Concurrent (Off): The targeting beam is
turned on at the same time as an enabled
illumination beam.
Interlaced (On): Toggles the aimer and illu-
mination beam.
0
0
0
9
On or
Off
On On On
Code Parameter/ Description
I.
D.
#
Accept
able
Input
Defaults Scanner Type
Min Max
Fac-
tory
Laser/
Linear
Imager
2D
Imag
er