Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 7)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas OM MN-1017EN 1
1 Operation
For general information on donut production,
refer to Section 5, “Donut-Making Helps.”
Taking Safety Precautions
Contact you local gas supplier and obtain
information about what to do if there is a gas
leak. Post this information in a prominent
location. Make sure that all employees know
what to do.
WARNING
To avoid the possibility of fire, explosion,
property damage, serious burns, and even
death, never store gasoline or any other
flammable liquid or vapor near the fryer.
WARNING
If you want to re-start the machine after
you have shut it down, do the following:
1. Move the POWER switch on the control
box to the OFF position. 2. Move the gas
control valve to the PILOT position.
3. Lightly press down the valve and turn it
to the OFF position. 4. WAIT 5
MINUTES. 5. Re-light the pilot, as
explained below.
FAILURE TO WAIT 5 MINUTES FOR
THE GAS TO DISSIPATE COULD
RESULT IN A FIRE OR AN EXPLOSION
WHEN YOU RE-LIGHT THE PILOT.
WARNING
To avoid serious injury or death, if you
smell gas or suspect a gas leak, proceed as
follows: 1. Turn off the gas. 2. Evacuate
the building. 3. Do not touch any electrical
switch or telephone until you are sure no
spilled gas remains.
The fryer is bolted to the work surface to prevent
it from tipping over and splashing hot liquid on
the operator.
WARNING
To avoid serious burns, other injury, and
even death, never move the fryer when
liquid is in it. If you want to move the
fryer, follow the instructions in “Moving
the Fryer,” in Section 1, “Installation” in
the Technical Supplement.