Belshaw Adamatic Mark II-Gas Donut Robot User Manual
Page 53

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas TS
MN-1018EN
13
THE DONUTS DROP AT THE WRONG TIME.
Possible Cause
What To Do
The hopper swing is adjusted incorrectly.
WARNING
To avoid injury, turn off the machine.
Adjust the hopper swing. See “Adjusting the
Hopper” in Section 1, “Installation.”
THE CONVEYOR IS JAMMED.
Possible Causes
What To Do
WARNING
To avoid being burned or otherwise injured,
before doing any of the following, turn off the
machine and allow the shortening to cool.
The hopper is too low and the cutter or the
hopper is catching on the flight bars.
Raise the hopper to 1”/2.5 cm above the flight bars.
Cooked food particles are wedged between a
chain opening and a sprocket tooth.
Clean to remove the food particles. Clean the Donut
Robot regularly and thoroughly.
The turner slot is packed with cooked food
particles.
Clean to remove the food particles.
The drop plate is out of position and is
interfering with the conveyor.
Reposition the drop plate.
Something is interfering with the free movement
of the turner cam and cam weight.
Remove the obstruction.
The heating element is bent and is interfering
with the turner.
Straighten the heating element.
The turner is out of position and is catching on a
flight bar below.
Lift and move the outfeed end of the conveyor to
disengage the conveyor coupling from the conveyor
drive shaft. Turn the conveyor back 2-3 pockets.
The turner will return to the correct position.