Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 16)

Belshaw Bros., Inc. www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
10 MN-1017EN Donut Robot Mark II-Gas OM
• Using a small saucepan or a metal
pitcher, scoop as much of the shortening
as you can into one or more large metal
buckets. Then lift the kettle out of the
fryer case and carefully pour the rest of
the shortening into a metal bucket. Be
careful not to disturb the sediment that
has accumulated in the bottom of the
kettle.
WARNING
Do not use plastic buckets. If the
shortening is not cool enough, the buckets
will melt; possibly causing you to be
burned, and causing shortening to get on
the floor.
WARNING
Do not allow the shortening to overflow the
buckets. Shortening will get on the floor,
and if the shortening is not cool enough,
you may be burned.
WARNING
Thoroughly clean and dry the floor if
shortening does spill. Shortening on the
floor can cause serious injury or loss of life.
11. Return the kettle to the fryer case, if you
have removed it.
12. Tilt the control box assembly back, raising
the thermostat and high limit out of the
kettle.
13. Lift the kettle out of the fryer case. Remove
and dispose of the remaining shortening and
the accumulated sediment. Dry the outside
of the kettle.
14. Put the kettle back in the fryer case.
15. Tilt the control box assembly down.
16. Put the drop plate and the turner assembly
back on the conveyor assembly.
17. Install the conveyor assembly.
Washing
1. Pour hot water into the kettle, up to the
normal level of the shortening. Add about
2 oz/59 ml of trisodium phosphate or other
appropriate cleaner.
2. Connect the machine to the power source.
Heat the solution to 200 °F/93°C. Turn on
the conveyor. Keep the solution at this
temperature for 15-20 minutes.
3. Turn off the conveyor and scrub the soiled
parts while the solution is under heat. Do
not use any abrasive cleaners or scrapers.
4. Turn off the heater and disconnect the
machine from the power source. Allow the
cleaning solution to cool to 100
°F/38°C.
5. Remove the conveyor and tilt the control
box back as you did before.
6. Remove the cleaning solution from the
kettle using one of these methods:
• If you have an optional Filter Flo
Siphon, remove its filter assembly. Then
use the Filter Flo to siphon the cleaning
solution into one or more large metal
buckets. (See the instructions in Section
4.) When the cleaning solution has
stopped draining, carefully carry the
buckets to the sink and slowly pour the
solution into the sink.
• Lift the kettle out of the fryer case,
carefully carry it to the sink, and slowly
pour the cleaning solution into the sink.
• Using a small saucepan or a metal
pitcher, scoop as much of the cleaning
solution as you can into one or more
large metal buckets. Then lift the kettle
out of the fryer case and carefully pour
the rest of the cleaning solution into a
metal bucket. Carefully carry the