Rinsing – Belshaw Adamatic Mark II-Gas Donut Robot User Manual
Page 17

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas OM
MN-1017EN
11
buckets to the sink and slowly pour the
solution into the sink.
WARNING
Do not use plastic buckets. If the cleaning
solution is not cool enough, the buckets will
melt; possibly causing you to be burned,
and causing cleaning solution to get on the
floor.
WARNING
Do not allow the cleaning solution to
overflow the buckets. Cleaning solution
will get on the floor, and if the solution is
not cool enough, you may be burned.
WARNING
Thoroughly clean and dry the floor if
cleaning solution is to spill. Liquid on the
floor can cause serious injury or loss of life.
7. Lift the kettle out of the fryer case, if you
have not done so already.
8. Rinse the kettle thoroughly and dry it on the
outside.
9. Install the kettle, tilt the control box
assembly down, and install the conveyor
assembly as before.
Rinsing
1. Pour clean water into the kettle, up to the
normal level of the shortening.
2. Connect the machine to the power source.
Heat the water to 200
°F/93°C.
3. Run the conveyor for 5-10 minutes.
4. Turn off the heater and disconnect the
machine from the power source. Allow the
water to cool to 100
°F/38°C.
5. Lift the conveyor assembly out of the fryer
case. Tilt the control box assembly back.
6. Remove the water from the kettle using one
of these methods:
• If you have an optional Filter Flo
Siphon, remove its filter assembly. Then
use the Filter Flo to siphon the cleaning
solution into one or more large metal
buckets. (See the instructions in Section
4.) When the cleaning solution has
stopped draining, carefully carry the
buckets to the sink and slowly pour the
solution into the sink.
• Lift the kettle out of the fryer case,
carefully carry it to the sink, and slowly
pour the cleaning solution into the sink.
• Using a small saucepan or a metal
pitcher, scoop as much of the cleaning
solution as you can into one or more
large metal buckets. Then lift the kettle
out of the fryer case and carefully pour
the rest of the cleaning solution into a
metal bucket. Carefully carry the
buckets to the sink and slowly pour the
solution into the sink.
WARNING
Do not use plastic buckets. If the water is
not cool enough, the buckets will melt;
possibly causing you to be burned, and
causing water to get on the floor.
WARNING
Do not allow the water to overflow the
buckets. Water will get on the floor, and if
the water is not cool enough, you may be
burned.