Assembling the cutter – Belshaw Adamatic Mark II-Gas Donut Robot User Manual
Page 44

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
4
MN-1018EN
Donut Robot Mark II-Gas TS
Figure 1-3. Inserting the Swing Column.
8. Connect the swing connecting rod to the
throw arm of the swing column. A locating
pin on the swing connecting rod rests in a
hole in the throw arm. See Figure 1-4.
Figure 1-4. Connecting the Swing
Connecting Rod.
9. Be sure your power source matches the
specifications on the machine. Connect the
machine to the power source.
10. Turn on the conveyor only and check to see
that it operates smoothly. The power switch
for the conveyor drive is on the control box.
Assembling the Cutter
Read this section only if you are preparing to
make cake donuts.
1. Set the cutter head assembly onto the swing
column. See Figure 1-5.
Figure 1-5. Mounting the Cutter Head
Assembly.
2. Mount the hopper by sliding the two
mounting studs on the hopper arch into the
notches on the bearing strut. Secure the
hopper with the thumb nuts. See Figure 1-6.