Belshaw Adamatic Mark II-Gas Donut Robot User Manual
Page 54

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
14
MN-1018EN
Donut Robot Mark II-Gas TS
THE CONVEYOR IS JAMMED CONTINUED.
Possible Causes
What To Do
The conveyor drive shaft and the drive motor
shaft are out of alignment.
Remove the cover of the drive assembly. Loosen the
four mounting spacers so the drive assembly can be
moved. Align the motor shaft with the conveyor
shaft. When they are aligned, tighten the mounting
spacers. Replace the cover.
THE MOTOR OVERHEATS.
Possible Causes
What To Do
The power requirements of the machine do not
match the power source.
Supply the correct power as specified on the data
plate.
WARNING
To avoid being burned, electrocuted, or otherwise
injured, before doing the following, turn off the
machine, allow the shortening to cool, and
disconnect the machine from the power source.
The motor is binding.
Repair or replace the motor.
The motor is defective.
Repair or replace the motor.
THE CUTTER CUTS DOUBLE WHEN YOU HAVE SELECTED ONE CUT PER
POCKET.
Possible Causes
What To Do
WARNING
To avoid being burned, electrocuted, or otherwise
injured, before doing any of the following, turn off
the machine, allow the shortening to cool, and
disconnect the machine from the power source.
The nylon brake dog is binding on the cutter
brake motor.
Loosen the brake dog. (brake dog is a flat metal gold
color piece under motor that moves the white plastic
lever) If the spring is missing or weak, replace it. If
the brake dog is worn, replace it.