Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 12)

Belshaw Bros., Inc. www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
6 MN-1017EN Donut Robot Mark II-Gas OM
WARNING
If the conveyor becomes jammed: 1. Turn
off the conveyor drive and the heater. 2.
Allow the system to cool down. HOT
SHORTENING IS DANGEROUS.
3. Determine the cause of the jamming.
4. Clear it. 5. Restart the system.
15. Continue adding shortening to the kettle to
maintain the proper shortening level (see
step 4). There are three ways to do this:
• Melt some shortening in a pan on the
stove and carefully pour it into the kettle.
• If you are using the optional EZ Melt,
transfer more shortening from it. See
your EZ Melt manual.
• If you are using the optional Shortening
Reserve Tank, push open the supply
valve.
16. Continue loading proof cloths onto the Feed
Table as needed.
17. To shut down the machine when you are
done:
a. Move the POWER switch on the control
box to the OFF position.
b. Turn the combination gas control valve
to the PILOT position. Lightly press
down the valve and turn it to the OFF
position.