Beisler 1265-4 - Manual (Page 83)

D-20
Programming Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
D.3
Programmierung
09 PHOTOCELL 15 ON / OFF
Switching state of photocell 15 (available only with optional bonding
station)
01 Enable function
00 Disable function
10 STACKER TO ROLLER UP
Duration while the roller is lowered and secured before the stacker
picks up
11 SENSING TIME CONTOUR
Response time for changing the puller speed
12 THREAD MON SENSITIVITY
Setting for the thread monitor
00 Disable function
01 High response sensitivity
99 Low response sensitivity
(setting depends on thread used)
13 HEAD POSITION UP
Lower needle position
14 STITCH LENGTH
Synchronisation of puller lowering position with sewing unit stitch
length
Procedure:
1. Setting the fixed stitch length at sewing unit handwheel 2 (ex-
ample: stage 6 is approx 3.2 mm stitch length).
2. Mark desired lowering position M of puller 1 on sewing piece.
3. Adjusting parameter 14 to the puller lowering position (tolerance
band 2 cm):
If the puller is lowered early (pos. A), the value is too high.
If the puller is lowered late (pos. B), the value is too low.
15 TOP FEEDING MAX POS.
Maximal fullness, value must not be changed
16 DIFFERENTIAL MAX POS.
Maximal fullness, value must not be changed