Beisler 1265-4 - Manual (Page 35)

Operating Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
B-25
B.3
Operation
Starting the machine cycle:
1. Select the seam at the operating panel.
2. Place trousers panel and knee lining on top of each other with the hems
being flush. The sequence depends on the selected sewing program.
3. Fig. 21: Slide trousers panels below the contour guide sliding shield 1
all the way to the stop, align hem flush with the sewing stop 4 at the
sewing head. Smoothen sewing pieces.
4. Pull the seam start point at the waistband of the trousers panel to just
before the reflection point 3 of the photocell 2.
5. Slide trousers panels into the sensor range of the photocell. When the
fabric interrupts the light beam at the reflective surface, the automatic
machine cycle is started automatically. The seam is sewn and serged.
NOTE - Restart
After the manual sewing process, the sewing program must
be restarted by pressing the P key.
NOTE - Position of the transport unit
To ensure sufficient freedom of movement, the transport unit
can be repositioned.
• Deactivate the transport unit using parameter 14 (= 00).
• Release clamp at lever 1.
• Tilt transport unit up and secure position by closing the
lever.
Fig. 21