Beisler 1265-4 - Manual (Page 33)

Operating Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
B-23
B.3
Operation
B.3.8 Securing the sewing pieces
The trousers panels are stocked at the upper tray, the knee lining is stocked
at the lower tray.
Bonding the trousers panels:
1. Make sure that the bonding sta-
tion heating module has reached
its operating temperature; the red
indicator 6 must be off.
1. Fig. 19: Line up knee lining 1
below the bonding clamp 2.
2. Press clamp switch 3; the
clamp lowers and secures the
knee lining. Simultaneously, a fi-
xed section of the bonding mesh
5 is advanced and removed
from the backing tape at the se-
parator.
3. Place trousers panel onto lining
and align properly. To change the
position of the knee lining, press
the clamp switch to open the
bonding clamp.
4. If the sewing pieces are aligned
properly on top of each other,
press the bonding switch 4.
The upper stamp is lowered,
presses knee lining, bonding
mesh, and trousers panel against the heated lower stamp and is then
raised.
5. The bonding clamp opens.
6. The trousers panels are now securely attached to each other and can
be lined up for the serging process at the sewing head.
Fig. 19