Beisler 1265-4 - Manual (Page 56)

Service Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
C-20
Abb. 11
C.5
Maintenance
C.5.13 Inserting the bonding strip at the bonding station
Fig. 11: The bonding strip rolls off a drum. The sepa-
rator removes the strip from the backing tape and pu-
shes it over the lower stamp 1 of the heating modu-
le. To insert the bonding strip:
1. Remove the disk 8 from the drum; the disk is
merely pushed on.
2. Attach the bonding strip roll 9 to the drum and
push the disk back onto the drum.
3. Rotate the pressure pad 5 of the guide 4 side-
ways.
4. Separate the bonding strip from the backing tape
6 and route the strip through the slot 3.
5. Rotate the pressure pad back onto the guide and
cut the bonding strip at the edge 2 of the guide.
NOTE - Position of the lower stamp
The proper function of the bonding unit
is only ensured if the lower stamp is in
the lowered position. By actuating the
switch 5, the lower stamp can be mo-
ved to the upper or lower position.
For cleaning, the lower stamp is moved
to the upper position, and the bonding
station heating module is switched off.