BECKHOFF EL9800 Basisplatine - Manual (Page 27)

Product overview
EL9800 25
6. Connect with the programming device
Select „Connect“ in the menu „Programmer“. While connection to the programming device is
established, downloading of a new operating system onto the programming device may take
place. This procedure takes some time and my not be interrupted. Not following this advice,
will cause permanent malfunction of the programming interface.
7. Loading the programming file
The menu topic „Import“ in the „File“ menu has to be selected and then the file „el9800-spi-
VXXX.hex“ has to be loaded.
8. In the following it can be checked if the correct PIC has been selected. Normally the device type
will be automatically identified, when importing the programming file. In the sub menu “Select De-
vice” of the menu “Configure” it can be checked, if the correct device is selected.
The device to be selected is: PIC24HJ128GP306
9. Programmi ng operation is started by selecting „Programm“ in the „Programmer“ menu.
10. After completion of the programming operation the PIC will automatically stay hold in reset state.
Two way of releasing the device from reset are available. The first one is to switch off the switch
SW600. Alternatively the device can be release from reset by clicking on the button “Release
from Reset” in the symbol bar of the development environment MPLAB. In any case the switch
SW600 has to be in position “OFF” before the USB cable is disconnected from the EL9800 base
board.