Avery Dennison Rewinder - Manual (Page 21)

Manual Rewind Option
06/01 Rev. 2.09 21
Activate rewinder
As an additional option the rewinder is a part of the TTX group Using the rewinder first time,
the software function has to be activated. Therefore use the printer menu.
1. Select SYSP
2. Select PEPH
3. Select RWND
4. Choose direction of rotation and select between DIRL (left – counter clockwise) and DIRR
(right –clockwise) – seen frontal towards the rewind core.
Fig. 1: Left side: Setting DIRL; Right side: Setting DIRR.
Attention: During OFFLINE Mode the rewinder is not moving. The rewinder is switched ON
and OFF using the CUT key !
Using the DIRR mode will result in not using the complete possible movement area of the
dancer arm. This is done via software (no additional adjustment necessary) – the reason for
is the angel of the dancer arm together with bigger outside diameter. So it is better to use
only a part of the movement area.
If there is no media in the media end sensor and is the sensor activated the rewinder is not
moving – as well not by pressing CUT.
The display is showing ST13 if the feed motor is not moving and the rewinder is not reaching
home position after 4 seconds of constant maximum speed.The rewinder will be switched
OFF.
Is the feed motor running and the rewinder is unable to reach the home position after 4
seconds of constant run – the rewinder will be re started ! Reason for – maybe the stepper
motor was blocked and has to be re started.