Avery Dennison Rewinder - Manual (Page 11)

Manual Rewind Option
06/01 Rev. 2.09 11
Clamp handle
Using the clamp handle you will fix either a core or the media itself to the rewind core!
The core and the handle are available in 3“ and 4“ diameter.
Assembly/Disassembly clamp handle
• responding to the used method you will
use the handle with a core or without
• using the paper core you have to fix the
material (with a sticky label) to the core
• after fixing the media with the handle
to the profile it should not be possible
move the media on the core
Roll profile
Same as the handle the roll profile is available
in a diameter of 3“ and 4“ - at the rear side you
can see two fixation points and flat area of the
axle guiding. Mounting the profile to the disc
watch this points.
Assembly/Disassembly roll profile
• the roll profile is mounted to the
guiding disc and fixed to a axle in
the centre
• disassemble the profile by open the
lock washer by hand (see picture)
• the profile can be removed
• the guiding disc is fixed with a separate
lock washer to the axle
Tooling
screw driver small