Avery Dennison 9406 Operator Handbook - Manual (Page 32)

3. Press
R
or
L
to display the parity you need, then
press E . You will see
PORT SETTINGS
< Parity >
4. Press Q to exit to the Setup menu.
5. Press
Q
to exit to the Main Menu.
NOTE: After changing settings in the Setup Menu, always
return to the Main Menu before turning your
printer off. The printer will not save changes to
these menus if you turn it off before returning to
the Main Menu.
Flow Control
The default setting for Flow Control is DTR. To change the
setting, follow the steps listed under "Finding Communication
Value Options." Then follow the steps below.
1. Press
R
until you see
PORT SETTINGS
< Flow Control >
2. Press
E
. You will see the previous setting, for example,
FLOW CONTROL
< DTR
The options for flow control are
None
XON/XOFF
DTR
9406 Operator’s Handbook
4-6