Avery Dennison 9406 Operator Handbook - Manual (Page 20)

The printer does not stop between labels in continuous mode,
but you can interrupt the batch. Press
Q in the middle of the
batch to suspend printing and bring the printer to the Pause
menu. Then, you can change the supply, printer values, etc.
and resume printing (or cancel the batch). If you enter new
values and resume printing, the printer finishes the current
batch. It only uses the new values when you print another
batch (unless described otherwise under that feature in this
manual).
Print Position
This function adjusts where data prints vertically on the supply.
You can adjust the print if it is too close to the top or bottom of
the supply, or goes over the pre-printed area ("MONARCH" in
the sample below). The adjustments are in dots (0.0052 inch),
which is the smallest measurement the printer recognizes. The
range is from -999 to +999 (5.20 inches), and the default is 0.
NOTE: If you change this value in the middle of a batch,
the change is immediate. It does not wait for the
next batch to make the change. Alter the number
as follows:
•
If the data is too close to the bottom of the supply,
increase the number.
•
If the data is too close to the top of the supply, decrease
the number.
9406 Operator’s Handbook
3-6