Avery Dennison 9406 Operator Handbook - Manual (Page 18)

3. Press
R
or
L
until you see the option you want. Then
press E . The printer calibrates to check the supply.
You will see
SUPPLY
< Supply Type >
4. Press
Q
to exit to the Setup menu.
5. Press
Q
to exit to the Main Menu.
NOTE: After changing settings in the Setup Menu, always
return to the Main Menu before turning your
printer off. The printer will not save changes to
these menus if you turn it off before returning to
the Main Menu.
Dispense Mode
You can print supplies in the following modes:
On-demand Prints one label at a time.
Continuous Prints one batch of labels at a time.
NOTE: The total print range (how close the printer starts
from the top of the label) depends on the
Dispense Mode you choose. For continuous
printing, the total print range is plus or minus 45
mils (1 mil equals 1/1000 of an inch). For
on-demand printing, it is plus or minus 65 mils.
9406 Operator’s Handbook
3-4