Avery Dennison 9406 Operator Handbook - Manual (Page 30)

3. Press
L
or
r R
to display the word length you need, then
press E . You will see
PORT SETTINGS
< Word Length >
4. Press Q to exit to the Setup menu.
5. Press
Q
to exit to the Main Menu.
NOTE: After changing settings in the Setup Menu, always
return to the Main Menu before turning your
printer off. The printer will not save changes to
these menus if you turn it off before returning to
the Main Menu.
Stop Bits
The default setting for Stop Bits is 1. To change the setting,
follow the steps listed under "Finding Communication Value
Options." Then follow the steps below.
1. Press
R
until you see
PORT SETTINGS
< Stopbits >
2. Press
E
. You will see the previous setting, for example,
STOPBITS
1 >
The options for Stop Bits are
1
2
9406 Operator’s Handbook
4-4