Avery Dennison Sierra Sport4 9493 System Administrator Guide - Manual (Page 16)

2-8 System Administrator’s Guide
3. Press D or U until you see the setting you need. For example:
4. Press A under e to save the setting or press under X to cancel without saving
changes. You return to the Setup menu.
Shut Down
You can set the printer to automatically shut down (turn off) completely after the printer has
been in sleep mode for a selected period of time. To continue using the printer, press p
to
turn it back on.
The default is disabled (the printer does not automatically shut down). However, you can set
the printer to shut down after being in sleep mode for 10 seconds or up to one hour.
Note: Low Power mode must be enabled to use Shut Down mode.
1. From the Setup menu, select Power Mgmt.
2. Select Shut Down.
A checkmark indicates the current setting.
3. Press D or U until you see the setting you need. For example:
4. Press A under e to save the setting or press under X to cancel without saving
changes. You return to the Setup menu.
S e r i a l P o r t
Use this menu to set the serial port communication values. These values provide the link for
normal online printing.
You need to set the printer’s serial communication values to match your computer's online
communications.
The serial communication values are shown below.
Option Choices Default
Baud Rate 1200/2400/4800/9600/
19200/38400/57600/115200 9600
Data Bits 7 Bits/8 Bits 8 Bits
Parity None/Odd/Even None
Stop Bits
1 Bit/2 Bits 1 Bit
Flow Control None/DTR/RTS/Xon/Xoff/Special DTR