Avery Dennison Sierra Sport4 9493 System Administrator Guide - Manual (Page 12)

2-4 System Administrator’s Guide
Setting the Margin Adjust
Use this option to adjust where the format prints horizontally on the supply. The range is -99 to
+99. The default is 00. Adjust the print if it is too close to the left or right of the supply, or
overtypes a pre-printed area.
1. From the Printer Setup menu, select Margin Adj.
2. Press D or U to decrease or increase the setting in one-step increments. Hold down the
buttons to decrease or increase in five-step increments.
Decreasing the value moves the printed data to the left, increasing the value moves the
printed data to the right.
3. When the setting you need is displayed, press e to save the setting or press X to cancel
without saving changes. You return to the Printer Setup menu.
Enabling the Demand Sensor
Use this option to enable or disable the on-demand sensor.
When the demand sensor is
♦ disabled, printing is activated by pressing .
♦ enabled, printing is automatic when the previously printed supply is removed.
To set the on-demand sensor:
1. From the Printer Setup menu, press D or U until Demand Sensor is highlighted.
2. Press e to enable or disable the on-demand sensor.
A checkmark appears when the sensor is enabled.
3. Press E to return to the Printer Setup menu.