Avalon Firestyles GreenStart Igniter 2 for Freestanding Stoves User Manual

Page 6

GreenStart Igniter 2 for Freestanding Stoves

Installation Instructions

(SKU 94400953)

Page 6 of 27

17601769.docx— 12/11/13

Attaching the Compressor Assembly to the Stove

Answer, Olympic, Rainier Only

NOTE: See the Addendum for Liberty igniter attachment.

1. Install the bolts into the rear heat shield on the stove:

• Answer: Use four (4) ¼-20x1-3/4” bolts.

• Olympic: Use four (4) ¼-20x1-3/4” bolts with ½” washers.

• Rainier: Use four (4) ¼-20x2-3/4” bolts into the rear heat shield on the stove.

NOTE: A few bolt threads should protrude from the stove.

NOTE: The washers are used as spacers, and are inserted between the stove and the compressor
assembly.

2. Hang the compressor assembly on the rear of the stove, as shown below. The 4 slots fit over the 4

bolts.

3. Tighten the bolts to secure the compressor assembly to the stove. A ratchet with an extension may

help with this task.

NOTE: Do not over-tighten these bolts.

NOTE: An extra outlet may be used with the Answer, Olympic and Rainier stoves; see page 3.

This completes attaching the compressor assembly to the Answer, Olympic, and Rainier.