Avalon Firestyles GreenStart Igniter 2 for Freestanding Stoves - Manual (Page 2)

GreenStart Igniter 2 for Freestanding Stoves
Installation Instructions
(SKU 94400953)
Page 2 of 27 17601769.docx— 12/11/13 © Travis Industries, Inc.
Packing List
• Igniter
Firebrick
•
½” Silicon gasket (Liberty only)
• Compressor
Assembly
• Cover
Box
•
Igniter (the igniter and cover box together are referred to as
“igniter assembly”)
•
(2) Cable Holders
• Gasket
• Lock-tie
• Cord
Restraint
•
Igniter Spacer (Answer, Rainier, Olympic,
Liberty)
•
(4) 1/2” washers (Olympic only)
•
(6) 10-24 x ½” screws
•
(4) 3/8-16 x ¾” bolts (Endeavor only)
•
(4) ¼-20 x 2-¾” bolts (Rainier only)
•
(4) ¼ - 20 x 1-¾” bolts (Answer, Liberty, Olympic)
Endeavor Answer, Liberty, Olympic Rainier
Large grommets Small grommets (4) Washers
(Liberty only) (Cape Cod only) (Olympic only)
Installation Tips
Remove the shipping screw from the pump box before proceeding with installation.
The igniter assembly must be installed before placing the stove.
If using a blower, install it first.
It is not necessary to install the blower first on the Endeavor, if applicable.
Wood placement is the key. Experiment with different sizes of wood and wood placement until you find a method that
works best for your wood quality and kindling.
The compressor assembly must be placed as shown in the instructions. Placing it on its side, near hot components, or
in a location where temperatures go below 40
° F will void the warranty and may lead to premature failure.