Avalon Firestyles Bed & Breakfast Installation - Manual (Page 24)

24 Installation
(for qualified installers only)
Travis Industries 4140312 100-01305
Approved Vent Configurations
Restrictor Position
 An exhaust restrictor and diffuser are built into the appliance to adjust the flow rate of intake air and
exhaust gases. Depending upon the vent configuration, you may be required to adjust the restrictor
and/or diffuser. The charts for acceptable vent configurations detail the correct vent restrictor and
diffuser positions.
Exhaust Restrictor Adjustment
If the diffuser is required to be in position # 2, you may wish to adjust the diffuser while the exhaust
restrictor is removed.
To Access the Restrictor:
Remove the face (with the stove
cool).
1
2
Determine the correct restrictor position (see the charts under "Approved
Vent Configurations" - the factory position is #1).
Lift up the adjustment plate and move it so the correct notch falls into the
slot on the adjustment bracket.
This restrictor is in position 1
(factory setting).
Adjustment Bracket
Adjustment
Plate
To adjust, lift the adjustment plate and
pull it forward
Restrictor Position
# 7
# 6
etc...
# 2
This restrictor is in position 3.
To Adjust the Restrictor: