Avalon Firestyles Bed & Breakfast Installation - Manual (Page 23)

Installation
(for qualified installers only)
23
Travis Industries 4140312 100-01305
Approved Vent
 Rear vent configurations use 8" diameter Simpson Dura-Vent Model Direct-Vent Pro (or GS)*.
 Top vent configurations use 8" or 6-5/8" diameter Simpson Dura-Vent Direct-Vent Pro (or GS)*. If
using 6-5/8" diameter vent, attach the 8" to 6-5/8" reducer (Travis part # 98900165) to the fireplace.
* Other vent may be approved with this fireplace. Check with the vent manufacturer for details.
 Always use the high-wind cap (or high-wind sconce cap, part # 58DVA-HSCH or 46DVA-HSCH).
 Installation instructions for Simpson Dura-Vent may be found at www.duravent.com.
Vent Installation
 Slide the vent sections together and turn 1/4 turn until the sections lock in
place.
 Screws are not required to secure the vent. However, three screws may be
used to secure vent sections together if desired.
 High temperature sealant is recommended at the appliance starter section
connection (use high-temperature silicone or Mill-Pac®).
 If disassembly is required, at time of re-assembly check to see if the vent
creates a tight fit. If it does not, apply high temperature sealant to the joints
of the affected sections.
 Horizontal sections require a 1/4" rise every 12" of travel.
 Horizontal sections require non-combustible support every three feet (e.g.: plumbing tape).
6-5/8" Diameter Vent
(minimum 12" vertical rise)
Reducer - # 98900165