beautypg.com

2 standard compliances, Table 1-1, Standard compliances – Artesyn COMX-P40x0 ENP2 Installation and Use (August 2014) User Manual

Page 16: Introduction

background image

Introduction

COMX-P40x0 ENP2 Installation and Use (6806800R95B)

16

Tamper detect pin to the COME connectors

On-board RTC and WDT device

Provide both remote and local thermal sensor

JTAG connector on module

Aurora testing points on module

12V power supplied to module through COME connectors

5V standby power from COME connector not required/used by module

1.2

Standard Compliances

The product is designed to meet the following standards.

Due to P4080 errata GEN-A009, Aurora ports are disabled by default in RCW and must be
re-enabled for debug. For assistance, contact Artesyn representative.

Table 1-1 Standard Compliances

Standard Description

UL60950-1 EN 60950-1 IEC
60950-1 CAN/CSA C22.2 No
60950-1

Safety Requirements

UL/CSA 60950-1
EN 60950-1
IEC 60950-1 CB Scheme

Legal safety requirements

FCC 47 CFR Part 15 Subpart B
(US), Class A
EN55022 Class A (EU)
AS/NZS CISPR 22 Class A
(Australia/New Zealand)
VCCI Class A (Japan)

EMC requirements (legal) on system level
(predefined Artesyn system)