Artesyn COMX-P40x0 ENP2 Installation and Use (August 2014) - Manual (Page 117)

BSP
COMX-P40x0 ENP2 Installation and Use (6806800R95B) 117
7.21.4 Build Misc Firmware
Misc Firmware for SCP-P4080-2G-ENP2 includes FMAN uCode and RCW image:
 FMAN uCode is misc/fman_ucode/fsl_fman_ucode_P3_P4_P5_101_8.bin
 RCW image is misc/rcw/rcw.bin
7.22 Deploy BSP Images
This section explains how to deploy BSP images. Assuming that you have built a BSP release
package COMX_P4080_V100B00.tar.gz by running ./build.sh V100B00 located at /local/
tmp/
.
7.22.1 Pre-Deployment Steps
The following steps must be performed before deployment:
1. Connect the board to your network using a network cable to the RGMII Ethernet port.
2. Setup a TFTP server in this network. Assuming that the IP address of this server is
192.168.0.100 and the root directory is /tftpboot/.
3. Create a comx_p4080/ in /tftpboot/ subdirectory.
4. Copy the COMX_P4080_.tar.gz file into the directory
/tftpboot/
comx_p4080/
on TFTP server.
5. Change current directory to /tftpboot/comx_p4080/.
6. Unzip the .tar.gz file to the current directory. The following files are extracted to the
COMX_P4080_V100B00/
:
 comx.dtb
 rcw.bin

rcw-codewarrior.bin
 rootfs_ext2.img

rootfs_nfs.tar.gz