ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook User Manual
Page 68
Administrator’s Handbook
68
set system fastpath hardware-enable [ off | on ]
Enables or disables the fastpath accelerator processor. Default is
off
.
set system lan-log [ on | off ]
Sets the 2247-N8 to collect or discard LAN log information. The default is on.
set system lan-log file-size [ 4096... 65536 ]
Assigns the maximum size (in bytes) for the LAN log file. The default is 16384.
set system lan-log file-count [ 2... 8 ]
Set the number of previous log files to store. The default is 4.
set system syslog enable [ on | off ]
Enables (on) or disables (off) the NVG589 syslog function. The syslog function is disabled by default. If syslog is
enabled, the following additional syslog settings may be configured:
set system syslog facility [ local0 ... local7 ]
set system syslog level [ 0 ... 7 ]
set system syslog log-system [ on | off ]
set system syslog log-firewall [ on | off ]
set system syslog log-igmp [ on | off ]
You must specify the syslog server’s IP address and any custom UDP port number to identify system logging
messages with the
commands. After the syslog server is specified, you may turn on any or all of the logging categories.
The receiving server must have a properly configured syslog server package active.
set system syslog server-ip
Specifies the IP address (in IPv4 dotted decimal notation or IPv6 colon-separated hexadecimal notation) of the
server that syslog messages will be sent to.
set system syslog server-port
Customizes the UDP port number that the syslog function marks messages to the logging server package with
(range: 1 - 65535, default: 514).
set system syslog facility [ local0 ... local7 ]
Specifies the local facility number that syslog messages are sent to (range: local0 - local7, default: local0).
set system syslog level [ 0 ... 7 ]
Sets the severity level of syslog messages the NVG589 will send to the syslog server. Each severity level
includes all higher-level messages (e.g; a level of 2 [Critical] will also send Alert and Emergency messages) . The
severity levels are arranged and enumerated as follows:
0 : Emergency