ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook - Manual (Page 49)

49
set ip igmp max-group-memberships value
Sets the maximum number of IGMP group memberships. Default is 20 .
set ip igmp default-fwd-allow [ on | off ]
Turns default forwarding on or off. The default is on .
set ip igmp snoop-entry-time seconds
The snoop-entry-time is the amount of time an entry will remain in the snooping table (in seconds) after being
added. An entry is added when a “JOIN” is seen from a multicast client. Any new joins (triggered by upstream
queries) will reset the timeout back to seconds. If no additional joins are seen, the entry will expire after sec-
onds. Default is
130 .
set ip igmp snooping-unreg-mode [ block | flood ]
The snooping-unreg-mode can be set to block or flood . This indicates what should happen to unregistered
multicast traffic – traffic that hasn't been subscribed to by any clients. If set to flood , the traffic will be sent to
all LAN ports. If set to block , the traffic will not be sent to any LAN ports; it will be dropped. Default is block .
set ip static-routes destination-network network_address enable [ on | off ]
Enables a static IP route in the 2247-N8 routing table
set ip static-routes destination-network network_address conn-oid connection_name WAN
Sets the connection identifier for the static route.
set ip static-routes destination-network network_address next-hop gateway_address
Sets the address of the gateway for the static route.
set ip static-routes destination-network network_address network network
Defines a static IP route in the 2247-N8 routing table
set ip static-routes destination-network network_address netmask netmask
Sets the netmask for the static route.
set ip static-routes destination-network network_address metric [ 0 - 255 ]
Sets the number of hops for the static route. The default is 1.
NTP commands
set ip ntp enable [ on | off ]
Enables or disables acquiring the time of day from an NTP (Network Time Protocol) server.
set ip ntp server-address server_address