ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook User Manual

Page 38

Administrator’s Handbook

ip6 conn

set ip6 conn name name enable [ on | off ]

Enables/disables the IPv6 connection named

name

. The default is off.

Specifies the type of tunnel for the IPv6 tunnel. The default is static.

set ip6 conn name name mtu [ 1280 - 1500 ]

Specifics the size of the maximum transfer unit. The default is 1500.

set ip6 conn name name side [ lan | wan ]

Specifies which connection uses tunnelling. The default is wan.

set ip6 conn name name mcast-forwarding [ off | on ]

Specifies the multicast forwarding is enabled for the tunnel. The default is on.

set ip6 conn name name icmp-echo-drop [ off | on ]

If enabled, all ICMP echo requests coming from the Internet will be dropped. The default is off.

set ip6 conn name name old-prefix-purge-timer

The time in seconds for which old, invalid prefixes are advertised with a lifetime of zero. The intent is to “flush
out” global prefixes on attached IPv6 hosts which suddenly become invalid.

set ip6 conn name name traffic-class-clear [ off | on ]

Specifies the traffic class. The default is off.

Static Connections

ip6 conn (type = static): Statically configured IPv6 connection.

set ip6 conn name name static link-oid link_name

Sets the connection named name to point to an associated link specified by the link-oid

link_name

set ip6 conn name name static ipaddr ipv6_address

Specifies a static IPv6 address.

set ip6 conn name name static prefix-length value

Specifies the prefix length of the connection's static IPv6 address. Default is

6rd Connections

ip6 conn (type = rd, side = wan): This WAN connection type is a 6rd tunnel over an IPv4 conn in accordance
with RFC 5569.