Physical interfaces commands – ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook User Manual
Page 58
Administrator’s Handbook
58
set management lan-redirect enable [ off | on ]
If set to
on
, if a WAN failure condition is detected, the LAN client's browser is redirected to a web page of fail-
ure and help text information. The redirect will only occur once, as the web UI maintains a state variable to
determine whether the redirect has occurred; to continually redirect would block the user from reconfiguring
the router.
set management lan-redirect missing-filter-notify [ on | off ]
If set to
on
, if a missing filter on the line is detected, the LAN client's browser is redirected to a web page of fail-
ure and help text information. The redirect will only occur once, as the web UI maintains a state variable to
determine whether the redirect has occurred; to continually redirect would block the user from reconfiguring
the router.
set management lan-access wan-cpe-mgmt-block [ off | web | all ]
Blocks management of the device WAN interface from the LAN via the web or all interface(s).
Physical interfaces commands
DSL interfaces
set physical dsl enable [ off | on ]
Turns the physical DSL interface
off
or
on
. Default is
on
.
set physical dsl annexm [ off | on ]
Turns optional DSL Annex M
off
or
on
. Default is
off
. If enabled, data rates can be as high as 12 or 24 Mbit/s
downstream and 3 Mbit/s upstream depending on the distance from the DSLAM to the customer's premises.
set physical dsl modulation auto [ off | on ]
Turns automatic DSL modulation
off
or
on
. Default is
on
.
set physical dsl modulation adsl2 [ off | on ]
Turns adsl2 DSL modulation
off
or
on
. Default is
on
.
set physical dsl modulation adsl2+ [ off | on ]
Turns adsl2+ DSL modulation
off
or
on
. Default is
on
.
set physical dsl modulation annex-l [ off | on ]
Turns annex-l DSL modulation
off
or
on
. Default is
off
.
set physical dsl modulation annex-m [ off | on ]
Turns annex-m DSL modulation
off
or
on
. Default is
off
.
set physical dsl bit-swap [ on | off ]
Turns DSL bit-swapping on or off. Bit-swapping is resilient to loss of hand-shake commands. Default is
on
.