ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook - Manual (Page 60)

Administrator’s Handbook
60
set physical dsl atm vcc [ 1 - 8 ] encap-type (ether-llc) [ ether-llc | ip-llc | ppp-llc | ether-
vcmux | ip-vcmux | ppp-vcmux ]
Specifies how data is encapsulated over ATM connections.
ether-lic = RFC-1483, bridged Ethernet, LLC-SNAP
ip-lic = RFC-1483, routed IP, LLC-SNAP
ppp-lic = PPP over ATM, LLC-SNAP
ether-vcmux = RFC-1483, bridged Ethernet, VC-muxed
ip-vcmux = RFC-1483, routed IP, VC-muxed
ppp-vcmux = PPP over ATM, VC-muxed
VC-muxed is the abbreviation for Virtual Circuit multiplexing
LLC-SNAP is the abbreviation for Logical Link Control Subnetwork Access Protocol
The default is ether-lic.
Ethernet interfaces
set physical enet [ 1 - 4 ] port media [ auto | 100-fd | 100-hd | 10-fd | 10-hd ]
Sets the Ethernet port’s media flow control: Automatic, 100 Mbps Full-Duplex, 100 Mbps Half-Duplex, 10 Mbps
Full-Duplex, or 10 Mbps Half-Duplex. Default is
auto .
set physical enet [ 1 - 4 ] port mdix [ auto | on | off ]
Sets the Ethernet port’s crossover detection. Default is off .
set physical enet [ 1 - 4 ] tx-queue queue_name
Attaches the egress queue template to the ethernet interface when the queue type is egress.
set physical enet [ 1 - 4 ] rx-queue queue_name
Attaches the ingress queue to the ethernet interface when the queue type is ingress.
set physical ensw max-age seconds
Sets the maximum delay on the Ethernet switch in seconds. Default is 300 (5 minutes).