Analog Way DI-VENTIX II - Ref. DVX8044 Programmer's Guide User Manual

Page 3

A3: Examples

Document notation:

1) Command without index : SWITCHER_MODE

Command to set the switcher mode to mixer mode: 0CM
Answer: CM0 which mean that the device is now working in mixer mode.

2) Command with 1 index : OFORMAT

Command to set the Main output format to XGA: 0,12OF
Answer: OF0,12 which mean that the output format is now 1024x768

3) Command with 2 indexes : PE_INPUTNUM

Command to set the input 4 displayed in Layer A of Next Preset: 1,1,4IN
Answer: IN1,1,4 which mean that the layer A of the next preset will display the input 4 signal

4) Read command without index : TAKEAVA

Read command to know if the TAKE command is available: TA
Answer: TA1 which mean that the device is ready to accept the TAKE command.

5) Read command with 2 indexes : SET_ASPECT_RATIO_OUT

Read command to know how is displayed a DVI signal plugged on the input 4: 3,1,sB
Answer: sB3,1,2 which mean that the DVI plug on input 4 is displayed full screen

A4: Error codes

Answer : E10 which mean invalid command
Answer : E11 which mean index value error (index value out of range)
Answer : E12 which mean index number error (too or few indexes)

Some commands are only available as [Read command], they are status and are colored in blue as this line.
Some commands are colored in yellow as this line to indicate they were added or modified in this version.

A5 COMMUNICATION PORTS