beautypg.com

Remote current programming by voltage source -46 – AMETEK SGI Series User Manual

Page 98

background image

Calibration and Verification

Sorensen SGI Series

3-46

M550221-01 Rev AA

3.10.2 Remote Current Programming by Voltage Source

Two inputs are provided for remote voltage-programming of the output current:
5 VDC full-scale and 10 VDC full-scale. The DC voltage source is connected
between Pin J1-10 (IP 5 V) for 5 VDC source, or Pin J1-16 (IP 10 V) for
10 VDC source, and the return Pin J1-23 (IP RTN).

The corresponding voltage-programming coefficients for output current are
(100% rated output current) / 5 VDC, or (100% rated output current) /10 VDC,
from the respective inputs with return to Pin J1-23 (IP RTN). This produces
transfer functions for output current, as follows:

Iout = Vdc * (100% rated output current) / 5 VDC), with Vdc in volts, or

Iout = Vdc * (100% rated output current) / 10 VDC), with Vdc in volts.

Note:

The return Pin J1-23 (IP RTN) must be referenced directly to, or within

±3 V, of the circuit common, Pins J1-6 and J1-24. See Figure 3-15 for
connection requirements.

+

-

1

13

23 IP RTN

COM 6

+

-

16 IP 10V

IP 5V 10

0-5 VDC
VOLTAGE
SOURCE

0-10 VDC
VOLTAGE
SOURCE

Figure 3-15. Remote Current Programming Using 0-5 VDC or 0-10 VDC Source