AMETEK SGI Series - Manual (Page 122)

Calibration and Verification Sorensen SGI Series
5-2 M550221-01 Rev AA
No routine maintenance on the SGI Series is required, aside from periodic
cleaning of the unit and inspection, as required by the environmental operating
conditions:
 Once a unit is removed from service, vacuum all air vents, including the front
panel grill.
 Clean the exterior with a mild solution of detergent and water. Apply the
solution onto a soft cloth, not directly to the surface of the unit. To prevent
damage to materials, do not use aromatic hydrocarbons or chlorinated
solvents for cleaning.
 Check external connections for integrity of insulation, loose contacts, and
proper torque.
 If there is any evidence of short-circuits or arcing, overheating, or corrosion,
contact the factory for recommended service.
.