AMETEK SGI Series - Manual (Page 88)

Calibration and Verification Sorensen SGI Series
3-36 M550221-01 Rev AA
screen). Use the NavPad to scroll down to Home Menu
Page 2 (there will be two inter-screen navigation arrows,
one at the top and one at the bottom of the screen). Press
F3, which jumps to the Language Menu, and then use the
NavPad to scroll to the user's native language.
3.8.10 Info
The Supply Information screen shows the date that the unit
was last calibrated, Model Number and Serial Number of the
unit, and version of the software. To access this screen,
from Home Menu Page 2 press F4.
3.8.11 Remote
Remote, F1, provides screens for either the Ethernet option
or the GPIB option, described in the following subsections.
E THERNET
The Ethernet Remote Menu displays the Ethernet MAC
address of the power supply, which cannot be edited.
Access the menu from Home Menu Page 3, F1 key. This
menu also displays in the IP IN USE: line, the IP address
presently in use from either a static IP setting or from the
DHCP server, depending on how assigned. The Baud Rate
is editable via the NavPad; changing it here changes the
rear panel RS-232 SCPI baud rate. Pressing the F2 key will
save the set baud rate. The initial factory setting is 19200.
LXI
The LXI submenu (F3 from the Remote Menu) displays
two settings required by the LXI requirements.
PING Response: enables or disables the power supply’s
response to a ping packet sent from a remote Ethernet host. To
change the setting to either ENABLED or DISABLED, move the
editing arrows to the PING Response: line by pressing NavPad
left/right, and then change the setting by pressing NavPad
up/down. Press F1 to Cancel the change and return to the
Remote Menu screen, or press F4 to Save the changed setting.
Identification: controls the LAN LED on the power supply’s
rear panel. ENABLED causes the LAN LED to flash for visual
identification. DISABLED causes the LAN LED to be steady-lit
to indicated the power supply’s connected status. To change
the setting, move the editing arrows to the Identification field by