Home timeout -35, Display brightness -35, Lock key -35 – AMETEK SGI Series User Manual
Page 87: Language -35, N 3.8.9

Sorensen SGI Series
Calibration and Verification
M550221-01 Rev AA
3-35
3.8.6 Home Timeout
The display jumps to this screen when the system has been
idle for 30 seconds. Press Escape or F4 to return to Home
Menu Page 1.
3.8.7 Display Brightness
Navigate from Home Menu Page 2, F1; use NavPad to dim
or increase the brightness. F1 saves the adjusted setting for
the remainder of the session and for future power-ups. F4
maintains the setting for the remainder of the session and
returns the brightness to its previously saved level at next
power-up.
3.8.8 Lock Key
To prevent changes due to accidental pressing of the keys,
Lock the keys from Home Menu Page 2, F2. This screen
appears until F4 is pressed; a confirmation screen will
appear with instructions to press Enter to unlock keys (see
Section 3.7.12, Other Screens) before returning to Home
Menu.
NOTE:
Lock Key only works while in the Constant-Voltage
or Constant-Current modes.
3.8.9 Language
The Language submenu allows the user to change the
default language for the menu selections. To select this
menu, from Home Menu Page 2 press F3 to go to the
Language Menu and select a language to work in. Pressing
F1 will save the selection and exit the Language Menu. The
next time the unit is powered up it will be in the last saved
language. Pressing F4 will keep the selected language only
for the remainder of the session and will revert to the
previously saved language at next power-up.
F
OREIGN
L
ANGUAGE
If the unit is set to a language foreign to the user, press the
escape key until Home Menu Page 1 appears. (Even in a
foreign language, the Voltage and Current values will still
display: value with the letter V and value with the letter A,
respectively. Also, there will be only one inter-screen
navigation arrow, which is located at the bottom of the