Zilog EZ80F91GA - Manual (Page 52)

Using the ZGATE Web Interface UM024502-1012
40
ZGATE Embedded Security Development Kit
User Manual
but it must also be less than or equal to half the Upper threshold. The Upper threshold
must be a value greater than 100 and also at least twice the size of the lower threshold.
To change one or more of these threshold values, position the cursor within the appropri-
ate input field and enter the desired value. If you prefer, press the Tab key to move
between input fields, or reposition the cursor to another input field to alter more than one
parameter. After all values have been entered, click the
Update button.
Clicking the Cancel button causes all changes to the threshold filtering parameters since
the last time the Update button was clicked (or the page was refreshed) to be discarded.
ZGATE Startup Settings Page
The first section of the ZGATE Startup Settings page displays the contents of the configu-
ration file ZGATE uses to set its initial configuration. The next time ZGATE is powered
on, it will again use the displayed configuration settings, effectively ignoring any run-time
changes that might have been made on any of the other ZGATE configuration pages or by
issuing ZGATE shell commands through the ZTP console. However, the ZGATE Startup
Settings page can be used to write the current ZGATE configuration (which reflects
changes made on other ZGATE configuration pages) to a file in the Zilog File System (but
only if the ZTP project includes ZFS support).
An example of the ZGATE Threshold filtering page is shown in Figure 11.