Zilog EZ80F91GA User Manual
Page 24
The ZGATE Embedded Security Development Kit
UM024502-1012
12
ZGATE Embedded Security Development Kit
User Manual
1. Launch ZDS II by navigating from the Windows Start menu to
Programs
→
Zilog
ZDS II – eZ80Acclaim!
→
ZDS II – eZ80Acclaim!
.
2. From the
File
menu in ZDS II, select
Open Project
, and navigate to the following file-
path:
3. Select the
ZGATE_Demo_ZGATE000100ZCOG.zdsproj
project from within the
ZGATE_Demo
folder and click
Open
. A list of source files will appear in the Work-
space panel section.
4. From the
Build
menu, select
Set Active Configuration
to open the Select Configura-
tion dialog box.
5. Select
RAM
, then click
OK
to close the Select Configuration dialog box.
6. From the
Project
menu in ZDS II, select
Settings
to open the Project Settings dialog
box. In the Project Settings dialog box, click the
Debugger
tab.
7. On the Debugger page, select
ZGATE000100ZCOG_RAM
from the Target list, then
select
USB Smart Cable
from the
Debug Tool
drop-down menu.
8. Click
OK
to close the Project Settings dialog box.
9. If you are prompted to rebuild any affected files, click
Yes
. Otherwise, choose
Build
from the menu bar, then click
Rebuild All
.
10. To run the application, select
Go
from the
Debug
menu.
11. After the application has started, console output should be visible in the terminal emu-
lation program.
For information about how to use the
ZGATE_Demo
sample program, please refer to the
Using the ZGATE Demo Sample Program
Recovering the ZGATE Image in eZ80F91 Internal Flash
The ZGATE demo program will not function unless the ZGATE binary image is present in
eZ80F91 internal Flash memory. If the ZGATE internal Flash image is accidentally erased
or overwritten, please
for assistance in repro-
gramming the ZGATE binary image into eZ80F91 internal Flash.
After the ZGATE binary image has been restored, it may be necessary to reprogram the
ZGATE demo application into the ZGATE Embedded Security Development Board. To
learn more, refer to the