TVLogic LVM-174W - Manual (Page 7)

Multi Format LCD Monitor 7
TALLY
POWER
SOURCE
SCAN
ASPECT
MARKER
F1
F2
F3
MENU/EXIT
UP/DOWN
ENTER
PGM
SPEAKER
LVM-174W : Front
3. Controls & Functions
● ●
Knob Control
- Easy to adjust user configuration using the
control Knob on the front of the monitor.
● ●
[TALLY] Lamp
- Tally lamp that can be toggled in green or
red using the REMOTE (RJ-45) port, RS-422
Serial communication or Network.
● ●
[POWER] Button
- Used to turn power on and off.
● ●
[OPERATE] Lamp
- Indicates condition and power status of unit.
- Light turns off when the power is
disconnected.
- Standby mode is indicated by a red LED light.
- Normal (active) mode is indicated by a Green
LED light.
- The Green light turns off when the monitor is
Normal(active) mode without input signal.
● ●
[SOURCE] Button
- Used to select Input Signal.
(SDI-A/B, HDMI, DVI Digital,
COMPOSITE1/2/3, S-Video, Component, RGB,
DVI Analog)
- Press the [SOURCE] Button to activate the
input menu-selection, then use the
Knob(UP/DOWN/ENGER) to select desired
input.
* See section “Other Functions [1] SOURCE
Button” for more information.
● ●
[SCAN] Button/ Lamp
- Used to change the Scan mode. Press
[ENTER] Button and the mode will be
changed as the following sequence.
OVER SCAN -> USER ASPECT -> ZERO SCAN ->
UNDER SCAN -> 1:1 SCAN -> FIT WIDTH
* See section “8. Other Functions [3] SCAN” for
more information.
# [USER ASPECT]: User can control the aspect
ratio by adjusting width and height of the
display.
- See section “8.Other Functions [8] User
Aspect” for more information.