TVLogic LVM-174W - Manual (Page 14)

14 Multi Format LCD Monitor
5. Menu Operations
[1] Picture [1] Picture(DVI Analog)
● ●
Brightness
- Used to set the brightness(=offset) level from
-100 to 100.
● ●
Contrast
- Used to set the contrast(gain) level from -100
to 100.
● ●
Chroma
- Used to set the saturation level from -50 to
50.
● ●
Phase
- Used to set the hue(phase) level from -40
to 40.
# Activates only in Analog signal input.
● ●
Aperture
- Used to set the sharpness level from 0 to 24.
● ●
NTSC Setup
- Used to set Black Level of NTSC video as
0(zero setup) or 7.5 IRE.
- Activated when NTSC video signal is input
through Composite 1/2/3 or S-VIDEO
terminal.
● ●
Key Lock
- Locks all buttons except power, input select
and menu buttons.
● ●
Brightness
- Used to set the brightness(=offset) level from
-100 to 100.
● ●
Contrast
- Used to set the contrast(gain) level from -100
to 100.
● ●
Chroma
- Used to set the saturation level from -50 to
50.
● ●
Phase
- Used to set the hue(phase) level from -40
to 40.
# If the phase is not adjusted well, some
stripes may appear on the screen or the
characters may be shown unclearly.
● ●
Clocks/Line
- Used to adjust the frequency between the
input signal and the monitor.
- If the frequency is off, the screen may be
fuzzy unstably or wavy pattern may
be shown.
● ●
Auto Adjustment
- Used to adjust the input signal automatically.
Phase, Clocks/Line and Image Position are
adjusted, too.
# If the screen is not adjusted clearly after the
Auto Adjustment, activate again this
function.
When the input resolution changes, the
monitor runs the Auto Adjustment itself.