TVLogic LVM-174W - Manual (Page 10)

10 Multi Format LCD Monitor
● ●
[F1][F2][F3] [F4][F5] button/lamp
- This Functions button is used to activate the
feature selected in [F1]~[F5] Button.
* See the section “8. Other Functions [1]
Function Key Set” for more information.
● ●
[SCAN] Button/ Lamp
- Used to change the Scan mode. Press
[ENTER] Button and the mode will be
changed as the following sequence.
OVER SCAN -> USER ASPECT -> ZERO SCAN
-> UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN ->
FIT WIDTH
* See section “8. Other Functions [3] SCAN ”
for more information.
# [USER ASPECT]: User can control the aspect
ratio by adjusting width and height of the
display.
- See section “8. Other Functions [4] User
Aspect” for more information.
● ●
[ASPECT] Button/Lamp
- Used to change the display various ratio.
- Activates in order of [16:9]-[4:3]-[2.35:1]-
[1.85:1]-[15:9]-[16:10]-[AUTO]-[ 16:9].
● ●
[MARKER] Button/Lamp
- Used to activate or inactivate the marker.
- The desired aspect ratio can be displayed on
the screen properly when the type of marker
selected from the main menu.
● ●
[H/V DELAY] Button/Lamp
- Used to check horizontal sync and vertical
sync simultaneously by moving the display
to the left, right, up and down.
- In this mode, the brightness of image
automatically increase for easy verification of
synchronized signals.
● ●
[BLUE ONLY]/[MONO] Button/Lamp
- Activates in the order of [OFF]-[Blue Only]-
[Mono]-[OFF].
- Press the button to remove red and green
from the input signal and display the screen
only under a blue signal. Press the button
again to activate mono mode.
- They are not available in RGB, DVI ANALOG,
DVI DIGITAL and HDMI modes.
● ●
[INFO.] Button
- Displays the current function and setting of
the monitor.
● ●
[MENU/EXIT] Button/Lamp
- Used to activate the OSD menu.
- When the OSD menu is activated, press this
button to exit from the menu.
● ●
[UP/DOWN/ENTER] Knob
- Used to move within the menu when OSD
menu is activated and is also used to
decrease or increase the value of the
selected feature.
- Press the knob to select the main menu and
sub menus.
- When OSD menu is inactivated, press
the knob to adjust the value of Brightness,
Contrast, Chroma or Aperture.
● ●
[POWER] Button
- Used to turn power on and off.
● ●
[OPERATE] Lamp
- Indicates condition and power status of unit.
- Light turns off when the power is
disconnected.
- Standby mode is indicated by a red LED light.
- Normal (active) mode is indicated by a Green
LED light.
-The Green light turns off when the monitor is
Normal(active) mode without input signal.
LVM-212W : Front
3. Controls & Functions