TVLogic LUM-560W (4K) - Manual (Page 8)

Controls, Indicators and Connections
FRONT
Multi F
orma
t L
CD M
onit
or
08
[DVI] Button/Lamp
- Used to select DVI input. By pressing the DVI button, depending on selected mode (UD, QUAD or
Single), previously selected DVI input selection displays.
- In Single Mode, press DVI button continuously to switch through DVI A~D.
[HDMI] Button/Lamp
- Used to select HDMI input. By pressing the HDMI button, depending on selected mode (UD,
QUAD or Single), previously selected HDMI input selection displays.
- In Single Mode, press HDMI button continuously to switch through HDMI A~D.
[SDI] Button/Lamp
- Used to select SDI input. By pressing the SDI button, depending on selected mode (UD, QUAD or
Single), previously selected SDI input selection displays.
- In Single Mode, press SDI button continuously to switch through SDI A~D.
[F1/MODE] Button/Lamp
- Used to select the display configuration.
- Selects order of operation: UD MODE -> QUAD MODE -> SINGLE MODE
[F2 ~ F5] Button/Lamp
- Shortcut key for KEY MAPPING feature in the OSD MENU.
- Selectable options are as follows :
1) UNDER SCAN
- Zooms in/out of the image without changing the aspect ratio. Also, displays the data at the
top of the horizontal blanking block.
2) [ASPECT] Button/Lamp
- Used to change the display ratio between 4:3 and 16:9.
3) [MARKER] Button/Lamp
- Used to activate/deactivate the marker.
- The type of marker at work may be selected on the main menu.
4) [BLUE ONLY/MONO] Button/Lamp
- Used to activate MONO mode or remove red and green from the input signal and display the
screen only under a blue signal.
- Press the button again to activate the Focus Assist mode which will indicate the border lines
of display in the color that can be selected in the Waveform menu.