KBC Networks ESML8P-PC2 - Manual (Page 95)

Ethernet Switch User Manual
Manual-ESML8P-PC2_Series-Rev1211
Copyright © KBC Networks Ltd.
Page 95 of 110 www.kbcnetworks.com
[Workport]: The amount
of work ports, this value
could not be less than
zero or be large than the
amount of member ports.
aggregator group
[GroupID] [Port-list]
nolacp
G Assign a static trunk
group.
[GroupID] :1~4
[Port-list]:Member port
list, This parameter could
be a port range (ex.1-4)
or a port list separate by a
comma (ex.2, 3, 6) switch(config)#aggregator group 1 2-
4 nolacp
or
switch(config)#aggregator group 1
3,1,2 nolacp
show aggregator P Show the information of
trunk group switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
no aggregator lacp
[GroupID]
G Disable the LACP function
of trunk group switch(config)#no aggreator lacp 1
no aggregator group
[GroupID]
G Remove a trunk group switch(config)#no aggreator group 2
VLAN Commands Set
Command Level Description Example
vlan database P Enter VLAN configure
mode switch#vlan database
Vlanmode
[portbase| 802.1q | gvrp] V To set switch VLAN mode. switch(vlan)#vlanmode portbase
or
switch(vlan)#vlanmode 802.1q
or
switch(vlan)#vlanmode gvrp
no vlan V No VLAN Switch(vlan)#no vlan
Ported based VLAN configuration
vlan port-based grpname
[Group Name]
grpid
[GroupID]
port
[PortNumbers]
V Add new port based VALN switch(vlan)#vlan port-based
grpname test grpid 2 port 2-4
or
switch(vlan)#vlan port-based
grpname test grpid 2 port 2,3,4
show vlan [GroupID]
or
show vlan
V Show VLAN information switch(vlan)#show vlan 23
no vlan group
[GroupID]
V Delete port base group ID switch(vlan)#no vlan group 2
IEEE 802.1Q VLAN
vlan 8021q name
[GroupName]
vid
[VID]
V Change the name of VLAN
group, if the group didn’t
exist, this command can’t
be applied. switch(vlan)#vlan 8021q name test
vid 22