KBC Networks ESML8P-PC2 - Manual (Page 94)

Ethernet Switch User Manual
Manual-ESML8P-PC2_Series-Rev1211
Copyright © KBC Networks Ltd.
Page 94 of 110 www.kbcnetworks.com
for giga ports,
and zero means no limit.
bandwidth out
[Value]
Set interface output
bandwidth. Rate Range is
from 100 kbps to 102400
kbps or to 256000 kbps
for giga ports,
and zero means no limit.
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth out 100
show bandwidth I Show interfaces
bandwidth control
switch(config)#interface fastEthernet 2
switch(config-if)#show bandwidth
state
[Enable | Disable]
I Use the state interface
configuration command
to specify the state mode
of operation for Ethernet
ports. Use the disable
form of this command to
disable the port.
switch(config)#interface fastEthernet 2
switch(config-if)#state Disable
show interface
configuration
I show interface
configuration states
switch(config)#interface fastEthernet 2
switch(config-if)#show interface
configuration
show interface states I show interface actual
states
switch(config)#interface fastEthernet 2
switch(config-if)#show interface states
show interface accounting I show interface statistic
counter
switch(config)#interface fastEthernet 2
switch(config-if)#show interface
accounting
no accounting I Clear interface
accounting information
switch(config)#interface fastEthernet 2
switch(config-if)#no accounting
Trunk Commands Set
Command Level Description Example
aggregator priority
[1~65535]
G Set port group system
priority switch(config)#aggregator priority 22
aggregator activityport
[Group ID]
[Port Numbers]
G Set activity port switch(config)#aggregator
activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G Assign a trunk group with
LACP active.
[GroupID] :1~4
[Port-list]:Member port
list, This parameter could
be a port range (ex.1-4)
or a port list separate by a
comma (ex.2, 3, 6) switch(config)#aggregator group 1 1-
4 lacp workp 2
or
switch(config)#aggregator group 2
1,4,3 lacp workp 3