KBC Networks ESML8P-PC2 - Manual (Page 36)

Manual-ESML8P-PC2_Series-Rev1211
Copyright © KBC Networks Ltd.
Page 36 of 110 www.kbcnetworks.com
5.2.6 System Event Log
This page allows the user to decide whether to send the system event log, and select the mode
which the system event log will be sent to client only, server only, or both client and server. What
kind of event log will be issued to the client/server depends on the selection on the Event
Configuration tab.
System Event Log—Syslog Configuration
• Syslog Client Mode: Select the system log mode—Client Only, Server Only, or Both.
‘Client Only’ means the system event log will only be sent to this interface of the switch,
but on the other hand ‘Server Only’ means the system log will only be sent to the remote
system log server with its IP assigned. If the mode is set in ‘Both’, the system event log
will be sent to the remote server and this interface.
• Syslog Server IP Address: When the ‘Syslog Mode’ item is set as Server Only/Both, the
user is required to assign the system log server IP address to which the log will be sent.
• Click Reload to refresh the event log displaying area.
• Click Clear to clear the displaying area.
• Make sure the selected mode and IP address, if needed, is correct and click ‘Apply’ for the
setting to take effect.
Syslog Configuration interface