KBC Networks ESML8P-PC2 - Manual (Page 43)

Manual-ESML8P-PC2_Series-Rev1211
Copyright © KBC Networks Ltd.
Page 43 of 110 www.kbcnetworks.com
5.2.9 IP Security
IP security function allows the user to assign up to 10 specific IP addresses that have permission
to manage the switch through the http and telnet services for securing switch management. The
purpose of giving permission to limited IP addresses is to allow only the authorized
personnel/device to do the management task on the switch.
• IP Security Mode: With this selection item set in the Enable mode, the Enable HTTP
Server, Enable Telnet Server checkboxes and the ten security IP fields will then be
available. If not, those items will appear in grey.
• Enable HTTP Server: With this checkbox ticked, Ethernet devices whose IP addresses
match any one of the ten IP addresses in the Security IP table will be given permission to
access this switch via the HTTP service.
• Enable Telnet Server: With this checkbox ticked, Ethernet devices whose IP addresses
match any one of the ten IP addresses in the Security IP table will be given permission to
access this switch via the telnet service.
• Security IP 1 ~ 10: The system allows the user to assign up to 10 specific IP addresses
for access security. Only when IP Security Mode is enabled can these 10 IP addresses
access and manage the switch through the HTTP/Telnet services.
• And then, click Apply to have the configuration take effect.
Note: Remember to execute the “Save Configuration” action, otherwise the new configuration
will be lost when the switch powers off.
IP Security interface