KBC Networks ESML8P-PC2 - Manual (Page 17)

Manual-ESML8P-PC2_Series-Rev1211
Copyright © KBC Networks Ltd.
Page 17 of 110 www.kbcnetworks.com
Wiring the Power Inputs 3.4
Please follow the steps below to wire power lines from the terminal block to the compliant
external DC power source.
1. Before wiring, make sure the power source is disconnected.
2. Using the wire-stripping tool, strip a short piece of insulation from the output wires of the
DC power source.
3. Identify the positive and negative feed positions for the terminal block connection. See the
symbols printed on the panel indicating the polarities and DC input power range in
voltage.
Plugs for Power 1 & Power 2
4. Insert the exposed wires into the terminal block plugs. Only wires with insulation should
extend from the terminal block plugs. Note that the polarities between the wires and the
terminal block plugs must be positive to positive and negative to negative.
5. Use a slotted screwdriver to tighten the captive screws.
Captive Screws for Fixing Wires
• Use Copper Conductors Only, 60/75 °°°° C , tightening to 5 lb-in
• The wire gauge for the terminal block should be in the range
between 12~ 24 AWG.
ATTENTION